Reconfigure ECU (See SD sheet for details. Inactive diagnostic trouble code retrieval ![]() Once the power is supplied, the switch is released and then pressed seven times. PLC Select 2M: A C(x) code is common with 4S/2M configurations that have been changed to a 2S/2M or 2S/1M. They should not be displayed for more than two seconds if code remains permanently displayed, replace the ECU. When you get to #7 this is important information to follow- “To enter the Reconfiguration Mode, the switch must be held in before the application of ignition power. X X Codes A(x) and C(x) are displayed when power is applied to the ABS ECU. The following table will tell you how to access those modes. ![]() ![]() To get to the active and non-active codes, Bendix has developed a system that allows you access to the ECM by using different modes.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |